Part of a series on
Water salinity
Salinity levels
Fresh water (< 0.05%) Brackish water (0.05–3%) Saline water (3–5%) Brine (> 5% up to 26%–28% max)
Bodies of water
Seawater Salt lake Hypersaline lake Salt pan Brine pool Bodies by salinity
v t e

Salinity (/səˈlɪnɪti/) is the saltiness or amount of salt dissolved in a body of water, called saline water (see also soil salinity). It is usually measured in g/L or g/kg (grams of salt per liter/kilogram of water; the latter is dimensionless and equal to ‰).

Salinity is an important factor in determining many aspects of the chemistry of natural waters and of biological processes within it, and is a thermodynamic state variable that, along with temperature and pressure, governs physical characteristics like the density and heat capacity of the water.

A contour line of constant salinity is called an isohaline, or sometimes isohale.

Salinity in rivers, lakes, and the ocean is conceptually simple, but technically challenging to define and measure precisely. Conceptually the salinity is the quantity of dissolved salt content of the water. Salts are compounds like sodium chloride, magnesium sulfate, potassium nitrate, and sodium bicarbonate which dissolve into ions. The concentration of dissolved chloride ions is sometimes referred to as chlorinity. Operationally, dissolved matter is defined as that which can pass through a very fine filter (historically a filter with a pore size of 0.45 μm, but later^[when?] usually 0.2 μm).^[2] Salinity can be expressed in the form of a mass fraction, i.e. the mass of the dissolved material in a unit mass of solution.

Seawater typically has a mass salinity of around 35 g/kg, although lower values are typical near coasts where rivers enter the ocean. Rivers and lakes can have a wide range of salinities, from less than 0.01 g/kg^[3] to a few g/kg, although there are many places where higher salinities are found. The Dead Sea has a salinity of more than 200 g/kg.^[4] Precipitation typically has a TDS of 20 mg/kg or less.^[5]

Whatever pore size is used in the definition, the resulting salinity value of a given sample of natural water will not vary by more than a few percent (%). Physical oceanographers working in the abyssal ocean, however, are often concerned with precision and intercomparability of measurements by different researchers, at different times, to almost five significant digits.^[6] A bottled seawater product known as IAPSO Standard Seawater is used by oceanographers to standardize their measurements with enough precision to meet this requirement.

Measurement and definition difficulties arise because natural waters contain a complex mixture of many different elements from different sources (not all from dissolved salts) in different molecular forms. The chemical properties of some of these forms depend on temperature and pressure. Many of these forms are difficult to measure with high accuracy, and in any case complete chemical analysis is not practical when analyzing multiple samples. Different practical definitions of salinity result from different attempts to account for these problems, to different levels of precision, while still remaining reasonably easy to use.

For practical reasons salinity is usually related to the sum of masses of a subset of these dissolved chemical constituents (so-called solution salinity), rather than to the unknown mass of salts that gave rise to this composition (an exception is when artificial seawater is created). For many purposes this sum can be limited to a set of eight major ions in natural waters,^[7][8] although for seawater at highest precision an additional seven minor ions are also included.^[6] The major ions dominate the inorganic composition of most (but by no means all) natural waters. Exceptions include some pit lakes and waters from some hydrothermal springs.

The concentrations of dissolved gases like oxygen and nitrogen are not usually included in descriptions of salinity.^[2] However, carbon dioxide gas, which when dissolved is partially converted into carbonates and bicarbonates, is often included. Silicon in the form of silicic acid, which usually appears as a neutral molecule in the pH range of most natural waters, may also be included for some purposes (e.g., when salinity/density relationships are being investigated).

The term 'salinity' is, for oceanographers, usually associated with one of a set of specific measurement techniques. As the dominant techniques evolve, so do different descriptions of salinity. Salinities were largely measured using titration-based techniques before the 1980s. Titration with silver nitrate could be used to determine the concentration of halide ions (mainly chlorine and bromine) to give a chlorinity. The chlorinity was then multiplied by a factor to account for all other constituents. The resulting 'Knudsen salinities' are expressed in units of parts per thousand (ppt or ‰).

The use of electrical conductivity measurements to estimate the ionic content of seawater led to the development of the scale called the practical salinity scale 1978 (PSS-78).^[9][10] Salinities measured using PSS-78 do not have units. The suffix psu or PSU (denoting practical salinity unit) is sometimes added to PSS-78 measurement values.^[11] The addition of PSU as a unit after the value is "formally incorrect and strongly discouraged".^[2]

In 2010 a new standard for the properties of seawater called the thermodynamic equation of seawater 2010 (TEOS-10) was introduced, advocating absolute salinity as a replacement for practical salinity, and conservative temperature as a replacement for potential temperature.^[6] This standard includes a new scale called the reference composition salinity scale. Absolute salinities on this scale are expressed as a mass fraction, in grams per kilogram of solution. Salinities on this scale are determined by combining electrical conductivity measurements with other information that can account for regional changes in the composition of seawater. They can also be determined by making direct density measurements.

A sample of seawater from most locations with a chlorinity of 19.37 ppt will have a Knudsen salinity of 35.00 ppt, a PSS-78 practical salinity of about 35.0, and a TEOS-10 absolute salinity of about 35.2 g/kg. The electrical conductivity of this water at a temperature of 15 °C is 42.9 mS/cm.^[6][12]

On the global scale, it is extremely likely that human-caused climate change has contributed to observed surface and subsurface salinity changes since the 1950s, and projections of surface salinity changes throughout the 21st century indicate that fresh ocean regions will continue to get fresher and salty regions will continue to get saltier.^[13]

Salinity is serving as a tracer of different masses. Surface water is pulled in to replace the sinking water, which in turn eventually becomes cold and salty enough to sink. Salinity distribution contributes to shape the oceanic circulation.

Limnologists and chemists often define salinity in terms of mass of salt per unit volume, expressed in units of mg/L or g/L.^[7] It is implied, although often not stated, that this value applies accurately only at some reference temperature because solution volume varies with temperature. Values presented in this way are typically accurate to the order of 1%. Limnologists also use electrical conductivity, or "reference conductivity", as a proxy for salinity. This measurement may be corrected for temperature effects, and is usually expressed in units of μS/cm.

A river or lake water with a salinity of around 70 mg/L will typically have a specific conductivity at 25 °C of between 80 and 130 μS/cm. The actual ratio depends on the ions present.^[14] The actual conductivity usually changes by about 2% per degree Celsius, so the measured conductivity at 5 °C might only be in the range of 50–80 μS/cm.

Direct density measurements are also used to estimate salinities, particularly in highly saline lakes.^[4] Sometimes density at a specific temperature is used as a proxy for salinity. At other times an empirical salinity/density relationship developed for a particular body of water is used to estimate the salinity of samples from a measured density.

Marine waters are those of the ocean, another term for which is euhaline seas. The salinity of euhaline seas is 30 to 35 ‰. Brackish seas or waters have salinity in the range of 0.5 to 29 ‰ and metahaline seas from 36 to 40 ‰. These waters are all regarded as thalassic because their salinity is derived from the ocean and defined as homoiohaline if salinity does not vary much over time (essentially constant). The table on the right, modified from Por (1972),^[15][16] follows the "Venice system" (1959).^[17]

In contrast to homoiohaline environments are certain poikilohaline environments (which may also be thalassic) in which the salinity variation is biologically significant.^[18] Poikilohaline water salinities may range anywhere from 0.5 to greater than 300 ‰. The important characteristic is that these waters tend to vary in salinity over some biologically meaningful range seasonally or on some other roughly comparable time scale. Put simply, these are bodies of water with quite variable salinity.

Highly saline water, from which salts crystallize (or are about to), is referred to as brine.

Salinity is an ecological factor of considerable importance, influencing the types of organisms that live in a body of water. As well, salinity influences the kinds of plants that will grow either in a water body, or on land fed by a water (or by a groundwater).^[19] A plant adapted to saline conditions is called a halophyte. A halophyte which is tolerant to residual sodium carbonate salinity are called glasswort or saltwort or barilla plants. Organisms (mostly bacteria) that can live in very salty conditions are classified as extremophiles, or halophiles specifically. An organism that can withstand a wide range of salinities is euryhaline.

Salts are expensive to remove from water, and salt content is an important factor in water use, factoring into potability and suitability for irrigation. Increases in salinity have been observed in lakes and rivers in the United States, due to common road salt and other salt de-icers in runoff.^[20]

The degree of salinity in oceans is a driver of the world's ocean circulation, where density changes due to both salinity changes and temperature changes at the surface of the ocean produce changes in buoyancy, which cause the sinking and rising of water masses. Changes in the salinity of the oceans are thought to contribute to global changes in carbon dioxide as more saline waters are less soluble to carbon dioxide. In addition, during glacial periods, the hydrography is such that a possible cause of reduced circulation is the production of stratified oceans. In such cases, it is more difficult to subduct water through the thermohaline circulation.

Not only is salinity a driver of ocean circulation, but changes in ocean circulation also affect salinity, particularly in the subpolar North Atlantic where from 1990 to 2010 increased contributions of Greenland meltwater were counteracted by increased northward transport of salty Atlantic waters.^{[13][21][22][23]} However, North Atlantic waters have become fresher since the mid-2010s due to increased Greenland meltwater flux.^[13][24]

• Desalination for economic purposes
  • Desalination of water
  • Desalination of soil: soil salinity control
  • Sodium adsorption ratio
• Measuring salinity
  • Salinometer
• Salinity by biologic context
  • In organisms generally, with particular emphasis on human health
    • Electrolytes
    • Fluid balance
    • Hypernatremia
    • Hyponatremia
    • Salt poisoning
  • In plants
    • Arabidopsis thaliana responses to salinity
  • In fish
    • Stenohaline fish
    • Euryhaline fish
• Salinity by geologic context
  • Fresh water
  • Seawater
  • Soil salinity
  • Thermohaline circulation
  • Paleosalinity
  • CORA dataset data on salinity of global oceans
• General cases of solute concentration
  • Osmotic concentration
  • Tonicity

• Lewis, Edward Lyn (1982). "The practical salinity scale of 1978 and its antecedents" (PDF). Marine Geodesy. 5 (4): 350–357. doi:10.1080/15210608209379432. Retrieved 2024-08-25.
• Mantyla, Arnold W. (April 1987). "Standard Seawater Comparisons updated". J. Phys. Oceanogr. (reprinted from its original publication in IEEE Journal of Oceanic engineering, vol. OE5, n° 1, Jan. 1980). 17 (4): 543–548. Bibcode:1987JPO....17..543M. doi:10.1175/1520-0485(1987)017<0543:sscu>2.0.co;2.

• "Thermophysical properties of seawater". web.mit.edu (MIT page on seawater properties, with Matlab, EES and Excel VBA library routines). Retrieved 2024-08-25.
• "Early Determination of Salinity: from Ancient Concepts to Challenger Results". salinometry.com (History of the salinity determination). Retrieved 2024-08-25.
• "Practical Salinity Scale — 1978". salinometry.com. Retrieved 2024-08-25.
• "Practical salinity calculator". salinometry.com. Retrieved 2024-08-25.
• "Algorithms on sea water". code10.info (equations and algorithms to calculate fundamental properties of sea water). Retrieved 2024-08-25.
• "Equations and algorithms to calculate salinity of inland waters". eos.ubc.ca. Retrieved 2024-08-25. (dead link)